Pentax V10 Digital Camera User Manual


 
4
Places of high temperature and humidity should be avoided. Particular care
should be taken regarding vehicles, which can become very hot inside.
Storing the camera where pesticides and chemicals are handled should be
avoided. Remove from case and store in a well-ventilated place to prevent
the camera from becoming moldy during storage.
As this camera is not waterproof, do not use the camera where it may come
in contact with rain, water or any other liquid.
Ensure that the camera is not subjected to substantial vibrations, shock, or
pressure. Use a cushion to protect the camera when it is subjected to the
vibrations of a motorbike, car, ship, etc.
The temperature range in which the camera can be used is 0°C to 40°C
(32°F to 104°F).
The liquid crystal display will become black at a high temperature but will
return to normal when normal temperatures are returned to.
The response speed of the liquid crystal display becomes slow at low
temperatures. This is due to the properties of the liquid crystal and is not a
fault.
Periodic checks are recommended every 1 to 2 years in order to maintain
high performance.
If the camera is subjected to rapid temperature changes, condensation
may form on the inside and outside of the camera. Therefore put the
camera in a bag or plastic bag, and take the camera out when the
difference in temperature has subsided.
Be careful not to allow dirt, mud, sand, dust, water, toxic gases or salt to
enter the camera as this may damage the camera. Wipe away any
raindrops or water droplets and allow the camera to dry.
Refer to “Precautions When Using an SD Memory Card” (p.28) regarding
the SD Memory Card.
Please note that formatting an SD Memory Card or built-in memory will
delete all data; however it may still be possible to recover that data using
off-the-shelf data recovery software. Please manage your camera memory
at your own risk.
Please do not press forcefully on the LCD monitor. This could cause
breakage or malfunction.
Be careful not to sit down with the camera in your back pocket as this may
damage the exterior of the camera or the LCD monitor.
When using a tripod with the camera, be careful not to overtighten the
screw in the tripod socket on the camera.
The AC plug cord supplied with the camera is for exclusive use with the
battery charger D-BC63. Do not use it with any other equipment.