Filter
Top Products
Before Use
-10-
Power Supply
ª Using the AC Adaptor
1 Connect the DC Input Lead to the Movie
Camera.
2 Connect the DC Input Lead to the AC
Adaptor.
3 Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown 1.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
ª Using the Battery
Before use, fully charge the Battery.
≥We recommend using Panasonic’s Battery.
≥We cannot guarantee the quality of this Movie
Camera when batteries of other companies are
used.
1 Attach the Battery to the AC Adaptor and
charge it.
≥Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
≥When charging the overdischarged battery,
the [CHARGE] Lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
1
the [CHARGE] Lamp blinks and the charging
time becomes longer than usual.
2 Attach the charged Battery to the Movie
Camera.
Disconnecting the Power Source
Set the [OFF/ON] Switch (43) to [OFF] and, while
pressing the [PUSH BATT] Button
(50), slide the
Battery or DC Input Lead upward to disconnect it.
≥For other notes concerning this item, see
-56-.
PUSH
BATT
ON
OFF
(50)
(43)
120.200B.book 10 ページ ２００４年２月２５日 水曜日 午後４時０分