Filter
Top Products
Accessory filter kits
• Polarizer kit to reduce reflections from the
flash units when photographing glossy or
glass subjects (PID No. 619909)
• Fluorescein kit for external ophthalmic
photography includes a #8 yellow barrier
filter and #47A blue exciter filters (PID No.
619908)
The numbers throughout the text refer to
the illustrations at the end of the book.
CAUTION: THIS CAMERA IS BATTERY POWERED.
TO AVOID ELECTRICAL SHOCK, CAMERA SHOULD
NOT BE EXPOSED TO OR IMMERSED IN WATER OR
OTHER FLUIDS, DISASSEMBLED, OR OPERATED IF
DROPPED OR DAMAGED. FOR REPAIR INFORMA-
TION, CONTACT NEAREST SERVICE CENTER.
Camera parts (Fig. 1)
a Shutter button
b Right hand grip
c Electronic flash units
d Lens
e Film door release button
f Film door
g Tripod socket (on bottom of camera)
h Ranging lights
i Magnification selector knob
j Battery compartm ent (inside hand grip)
k Left hand grip
l Viewfinder
m Control panel
Load the batteries
The camera requires four AA batteries to
provide power for the ranging lights. Alka-
line batteries (standard or rechargeable)
are recommended; rechargeable NiCad
batteries also can be used.
The battery compartment is located in
the handgrip; slide the battery door open
(2); the battery holder will pop up. Un-
snap the battery clip (3) and remove the
battery holder (4). Insert the batteries in
the orientation shown on the holder (5).
Replace the battery holder, snap on the
clip and close the door.
Important: Remove the batteries and
store them separately if the camera will
not be used for an extended period of
time. Use of the camera in extreme heat
or cold will shorten battery life.
See
Battery cautions.
4 English