Filter
Top Products
Page 2 of 3
Installing 2150 Camera Drivers and Direct Interface From CD-ROM
Windows 98 Drivers (this is a two-step process)
1. Plug camera into electrical power
2. Plug in USB Cord to computer and to camera
3. Turn camera on
4. Add New Hardware Wizard (box appears on screen)
a. Click Next
b. Click on “Specify a location” and unclick Floppy disk drive & CD-ROM drive
c. Insert 2150Drivers CD into CD drive
d. Click Browse
e. Choose correct drive for CD
f. Click 2150 Windows Drivers
g. Click on correct Operating System = Win 98_SE_ME
h. Click OK
i. Click Next
j. Click Next
k. Click Next
l. Click Finish
5. Next install process
a. Click Next
b. Click Next
c. Click Next
d. Click Next
e. Click Finish
6. Next install process
a. Click Next
b. Click Next
c. Click Next
d. Click Next
e. Click Finish
Install PDC2150 Direct Interface
7. Keep CD in computer
a. Click on Start
b. Click on Run
c. Run destination = D:/setup (where D: is your CD-ROM drive)
8. When PDC2150 Setup box appears
a. Click Next
b. Click Yes – Software License Agreement
c. Click Next – Choose destination location – default to C:\ITC\
d. Click Finish
Windows 2000 Drivers (this is a two-step process)
1. Plug camera into electrical power
2. Plug in USB Cord to computer and to camera
3. Turn camera on
4. Add New Hardware Wizard (box appears on screen)
a. Click Next
b. Click on “Specify a location”
c. Insert 2150Drivers CD into CD drive and click Next
d. Click Browse
e. Choose correct drive for CD
f. Click 2150 Windows Drivers
g. Click on correct Operating System = Win 2K
h. Click Open
i. Click OK
j. Click Next
k. Click Finish