Filter
Top Products
Charging the battery
Your LED336 light includes a battery and charger. To charge the battery:
1. Align the contacts of the battery with the battery charging contacts on the charger. Gently slide
the battery onto the charger until you hear a slight click. The battery will be locked into place.
2. To remove the battery, press down on the lock tab at the end of the battery and slide the battery
away from the charger.
3. Plug the charger into an A/C power source. The charge indicator will glow red.
4. When the battery is fully charged, the battery indicator will glow green (approximately 4 hours).
WARNING: Only use the battery type specified for this charger. Using an incompatible battery
may cause fire, explosion, or personal injury.
Safety Tips
To prevent any damage to your product or personal injury, please read the following safety
precautions before operation.
1. To prevent the risk of fire or electric shock, do not expose this device to rain or moisture.
2. Use of incorrect battery or power supply may cause this unit to be damaged or become
inoperable. Please note the correct operating voltage before use.
3. If this unit emits smoke or a strange odor, disconnect the power immediately to prevent further
damage to the equipment or personal injury.
4. Do not disassemble this product. If the equipment is dropped or damaged by other means,
please disconnect the power and return it to your dealer for service.
5. Remove the battery and power supply for storage and transportation. Leaving the battery or
power supply attached for long periods of time without use may cause fire or other unsafe
conditions.
6. Keep out of reach of children. This is not a toy and may cause injury if handled improperly.
7. Be sure to observe all instructions for proper use of the battery and charger. Improper operation
may cause the battery to leak or burst.
8. Do not disassemble or short circuit the battery. Do not expose the battery to flame or excessive
heat. Do not immerse the battery in water or other fluids. All of these actions can cause fire,
explosion, or personal injury.
9. This light is very bright. Avoid staring at the light when it is on. Lengthy exposure to the eyes
could cause vision impairment.
10. Do not cover the ventilation grille which could cause excessive heat build up inside the light and
cause damage.
11. Do not expose the light to water or other liquids which could cause a short circuit and damage the
light.
12. Avoid placing the light near alcohol, gasoline, or other flammable or volatile solvents that could
cause fire or damage to the light.
13. Do not pick up your camera by the light when it is attached. This could cause damage to the light
and/or your camera.