Filter
Top Products
30
The displays of the two Remote Qflashes will automatically change to R1
and R2.
15.2 Select the Mode and settings for all flashes
Always select the settings you desire for the Control Qflash first. Those
settings determine the choices you have for the Remotes.
• Press Set G until “C” is blinking. (If “R1” or “R2” is blinking instead,
press the Up J/Down L buttons until “C” blinks).
• Press Set G again. The mode of the Control flash will blink.
Use the Up J/Down Lbuttons to select the mode. The choices are Man,
Auto, QTTL and OFF* (see 15.3 – Wireless Setup - Important Notes)
• Press Set G again to set the parameters for the mode selected. For
example, power (1/64 to 1/1) for Man, F# for Auto, etc. There are no
settings for TTL or OFF modes.
• Set the fill/flash ratio. To change the ratio, turn the “Fill” dial on the
QTTL adapter.
Next, from the Control Qflash panel, select the settings for the Remote
Qflash(s):
• Press Set G until either “C”, “R1” or “R2” blinks in the display.
If necessary, press Up J/Down L until “R1” blinks to set the
parameters for Remote 1, or until “R2” blinks for Remote 2.
• Press Set G again and the Mode of R1 or R2 will blink.
Use the Up J/Down L buttons to select the Mode of the Remote Qflash.
• Press Set G again to set the parameters of the Mode selected.
15.3 Selecting a different flash as the control flash
To select a different flash as the control, press the Mode I button on the
Control Qflash and use the Up J/Down L button. The Qflash displays will
prompt you to select the Control flash for the “Wired Control” setup. Press
the Mode I button on the Qflash that you want to be the Control Qflash.
15.4 Changing Remote 1 to Remote 2 or Remote 2 to Remote 1
Press the Mode I button on the Remote Qflash and use the Up J/Down
L button to change from Remote 1 to Remote2.
Note : If there is already a Remote 2 Qflash connected, it will automatical-
ly change to Remote 1
QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 34