Ricoh 06424 Digital Camera User Manual


 
3
48
Shooting
3 To compensate the flash
output or when K is
selected, press B and then
use V to adjust the value.
Press M to reset to the default
setting.
4 Press E.
The camera returns to standby mode.
5 Press 1.
The built-in flash is popped up.
t Memo
The flash modes that can be selected vary depending on the
capture mode.
*1 The flash is not available in some scene modes. (p.88)
You cannot take pictures while the flash is being charged.
If you want to take pictures while charging the flash,
set [20 Release While Charging] in the E3 menu.
Depending on the lens being used, the use of the built-in flash
may be limited. (p.91)
When the built-in flash is used in J mode, the shutter speed
automatically changes over a range from 1/180 seconds to
a slow shutter speed depending on the lens being used.
The shutter speed is locked at 1/180 seconds when a lens
other than a DA, DA L, D FA, FA J, FA or F lens is used.
When the built-in flash is used in I, K or L mode, any
desired shutter speed of 1/180 seconds or slower can be set.
The built-in flash is optimum for a subject at a distance from
approx. 0.7 m to 5 m. Vignetting may occur when used at
a distance closer than 0.7 m (this distance varies slightly
depending on the lens being used and the sensitivity setting).
For details on using an external flash, refer to “Functions
when Using an External Flash” (p.93).
Capture Mode Selectable Flash Mode
R, S
*1
A, B, C, D
W, G, H, J C, D, E, F, H, K
I, K, L, M
C, D, G, K
+1.0+1.0
0.00.0
Auto Flash DischargeAuto Flash Discharge
CancelCancel
OKOK
Sensitivity
Guide
Number
Sensitivity
Guide
Number
ISO 100
Approx. 10
ISO 3200
Approx. 56.6
ISO 200
Approx. 14.1
ISO 6400
Approx. 80
ISO 400
Approx. 20
ISO 12800
Approx. 113
ISO 800
Approx. 28.3
ISO 25600
Approx. 160
ISO 1600
Approx. 40
ISO 51200
Approx. 226
e_kb558_om.book Page 48 Tuesday, September 16, 2014 11:59 AM