Filter
Top Products
Alkaline Battery Charger RGD-CT505 User Manual
2
How to Use
1. Plug adapter to wall
outlet and insert tip
to charger.
2. Insert the battery/batteries
into the charging
Channels, observing the
correct polarity.
3. Charging complete: red,
green LEDs flash alternately
for 5 times before the LED
light remains green
◎ Plug in the adapter to the wall outlet(AC100V-240V).
◎ Connect the adapter to the Alkaline Battery Charger, and the LED indicator will flash in red
and green light once in turn.
◎ Stow the batteries into the charger and connect them to the appropriate poles.
Standby mode: LED indicator shows steady green light which means this unit is ready.
Low voltage batteries below default setting or aged Batteries: LED indicator shows off
The LED indicator shows off or steady green when old or damaged batteries inserted to
the charger. In this case the charger won't charge the damaged batteries, so please
remove the batteries from the charger and dispose of at your nearest recycling
point/center.
New batteries and fully charged batteries: LED indicator will flash in green light for five
times and then enter the standby mode.
It is a normal phenomenon if the temperature of the batteries rises slightly during
charging process.
◎ LED Indicator Status: Red light, meaning it is in the charging mode.
Charging time: 4 hours
Overheat warning indication: charging circuit will cut off automatically.
LED Indicator Status: Green and Red light flashes for 5 times by turns. The charger will
return to charging mode only when its temperature is back to normal condition.
Batteries fall off: Charging circuit will cut off automatically. LED Indicator Status: Green
light flashes once and goes off.
Charging completes: Charging circuit will cut off automatically.
LED Indicator Status: Green and Red light flashes for five times by turns. Then the
charger returns to the standby mode, the status of LED indicator is green.
The charged batteries are ready to be used.