Rosewill RGD-CT505 Camera Accessories User Manual


 
Alkaline Battery Charger RGD-CT505 User Manual
3
D) The Definition of LED Indicator
Power on : LED indicator shows green light.
Charging mode : LED indicator shows red light.
Charging completed mode : LED indicator will flash Green and Rd light for five times by
turns, then LED indicator status is green.
New batteries and fully charged batteries : LED indicator will flash in green light for five
times and then enter the standby mode.
Low voltage batteries below default setting or aged Batteries : LED indicator shows off
The LED indicator shows off or steady green when old or damaged batteries inserted to
the charger. In this case the charger won’t charge the damaged batteries, so please
remove the batteries from the charger and dispose of at your nearest recycling
point/center.
Batteries fall off (insert incorrect) : LED light flashes one time and turns off.
Overheat : LED indicator Green and Red light flashes by turns.
E) Caution
Please read through and follow the instruction and caution.
Alkaline Battery Charger is applicable to charge used Alkaline and NiMH batteries
DO NOT charge used Carbon-Zinc/NiCd Batteries or Old batteries that are not in use for
long time. This could result in overheat of batteries or leak of chemical substances and in
turn damages to the charger. The one-year warranty is not applicable to the above
situation.
It is recommended to use the charger with quality alkaline batteries which are newly
produced and discharged. DO NOT charges the giveaway batteries of lower quality that
usually comes along with electronic devices.
Alkaline battery doesn’t have the memory function. So it’s recommended for used
alkaline batteries with a longer charging time than use time for a better effect.
It is recommended to charge used NiMH batteries twice consecutively (or around 8 hours)
before use for a better effect.
DO NOT charge the deformed, damaged, rusted or leaked batteries with the charger.
Make sure the charger is in the standby mode before charging any used batteries to
prevent insufficient charging time. Otherwise, the problem can be solved by turning on
the power again.
Low voltage batteries below default setting or aged Batteries : LED indicator shows off or
steady green when old or damaged batteries inserted to the charger. In this case the
charger won’t charge the damaged batteries, so please remove the batteries from the
charger and dispose of at your nearest recycling point/center.
It’s recommended to store used batteries in containers, to avoid mixing batteries altogether,
and prevent contact between negative and positive poles of batteries.