Filter
Top Products
E
25
E
24
Connecting Cables and Checking Operations
1. First connect one end of the BNC cable to the VIDEO OUT.
2. Next, connect the other end of the BNC cable to the video input terminal of the
monitor.
3. Then, plug in the power adapter. Use a “minus” screwdriver to connect one part
of the power adapter consisting of two lines to the power input terminal of the
Camera as follows. (GND: marked with a white line on the cable)
4. Decide on the type of power source you want to use and then adjust the power
selection switch located at the bottom of the power adapter. Then, plug the
power adapter into the power receptacle.
5. If the camera operates normally, the following screen will be displayed for 5 sec-
onds before it disappears.
6. When controlling an RS485, please check the following:
- Communication Speed: 4800 bps ~ 38400 bps
- Data Bit Number: 8 bits
- Stop Bit Number: 1 bit
- Parity Bit: None
SAMSUNG PROTOCOL
ADDRESS 0
TYPE
RS-485, HALF
BAUD RATE 9600
LENS OK
ROM VER 1.000
EEP VER 1.000
00577A-SCC-C9302(F)P-E/R/P 9/30/06 10:54 AM Page 24