Filter
Top Products
54
Starting the slide show
Images can be displayed continuously at pre-set intervals.
You can view the slide show by connecting the camera to an external monitor.
Configure the interval for the slide show
: Configure the length of time to display each picture in the slide show.
1. Press the play mode button and press the menu button.
2. Press the LEFT/ RIGHT button and select the [SLIDE]
menu tab.
3. Select the [INTERVAL] sub menu by pressing the UP/
DOWN button and press the RIGHT button.
4. Use the Up/Down Button to establish the display interval.
- Slide Show Display Interval : OFF, 1 ~10 seconds
5. Use the Right Button to start the slide show.
Use the Pause ( ) Button to pause and resume the slide show.
To cancel the slide show in the middle of the show, press the Pause button and the LEFT
or RIGHT button.
The loading time depends on the image size and quality.
The slide show will start from an image that was displayed on the LCD monitor.
The [PWR OFF] function can t be activated.
While the slide show is playing, only the first frame of an MOVIE file is displayed.
INFORMATION
Configure slide show repeat mode
: Automatically restart the slide show after displaying all pictures.
Steps 1 and 2 are the same as for the [INTERVAL] section.
3. Select the [REPEAT] sub menu by pressing the UP/
DOWN button and press the RIGHT button.
4. Use the Up/Down Button to select the repeat mode.
[ON] : The slide show will repeat until turned off.
[OFF] : The slide show will not repeat after the first
showing.
5. Press the OK button to confirm the setting.
6. Press the OK button again and the slide show will start.
SLIDE
INTERVAL
REPEAT
EFFECT
MOVE: CHANGE:
OFF
SLIDE
INTERVAL
REPEAT
EFFECT
BACK:
SET:OK
ON
OFF