Filter
Top Products
ŝ70Ş
FAQ
ƃWhen codec for play back the movie clip isn’t installed
ƍInstall the codec as listed below.
[ Installing codec for Windows ]
1) Insert the CD provided with the camera.
2) Run the Windows Explorer and select [CD-ROM drive:\XviD] folder and click
the XviD-1.1.0-30122005.exe file.
ſThe XviD codec is distributed according to the GNU General Public License
and everyone can copy, distribute and change this codec. This License
applies to any program or other work which contains a notice placed by the
copyright holder saying it may be distributed under the terms of this General
Public License.
For more information, see the License documents
(http://www.gnu.org/copyleft/gpl.html).
ƃWhen the DirectX 9.0 or later is not installed
ƍInstall the DirectX 9.0 or later
1) Insert the CD provided with the camera
2) Run the windows explorer and select the [CD-ROM drive:\ USB Driver\
DirectX 9.0] folder and click the DXSETUP.exe file.
The DirectX will be installed. Visit the following site for downloading the
DirectX. http://www.microsoft.com/directx
Case 6 When I open the Device Manager (by clicking Start ƍ (Settings) ƍ
Control Panel ƍ(Performance and Maintenance) ƍSystem ƍ
(Hardware) ƍDevice Manager), there are Unknown Devices or Other
Devices entries with a yellow question mark (?) beside them or
devices with an exclamation mark (!) beside them.
ƍ Right-click on the entry with the question (?) or exclamation (!) mark
and select "Remove". Restart the PC and connect the camera again.
For Windows 98 PC, remove the camera driver also, restart the PC,
and then reinstall the camera driver.
Case 7 In some security programs (Norton Anti Virus, V3, etc.), the computer
may not recognise the camera as a removable disk.
ƍStop the security programs and connect the camera to the computer.
Refer to the security program instructions about how to temporarily
disable the program.
Case 8 The camera is connected to the USB port located on the front of the
computer.
ƍWhen the camera is connected to the USB port located on the front of
the computer, the computer may not recognise the camera. Connect
the camera to the USB port located on the back of the computer.
ƈWhen the movie clip doesn’t play back on the PC
ſWhen the movie clip recorded by the camera doesn’t play back on the PC,
the causes are mostly due to the codec installed on the PC.