Filter
Top Products
ŝ11Ş
Connecting to a Power Source
Battery life Number of images Recording time
Approx. 90 MIN Approx. 180 Approx. 90 MIN
Using the fully charged battery, Auto
mode, 10M image size,
Fine image quality, Shot to shot interval
: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the flash on every second shot.
Using the camera for 5 minutes and
then Powering it off for 1 minute.
Still image
Movie
Based
on the
following
shooting
conditions
Based
on the
following
shooting
conditions
Using the fully charged
battery
640X480 image size
30fps frame rate
ƈNumber of images and battery life : Using the SLB-0837B
ſThese figures are measured under Samsung’s standard conditions and shooting
conditions and may vary depending on the user's methods.
Important information about battery usage.
ƃWhen the camera is not used, turn off the camera power.
ƃPlease remove the battery if the camera will not be used for long periods.
Battery can lose power over time and are prone to leaking if kept inside the
camera.
ƃLow temperatures (below 0°C) can affect the performance of the battery
and you may experience reduced battery life.
ƃBattery will usually recover at normal temperatures.
ƃDuring extended use of the camera, the camera body may become warm.
This is perfectly normal.
INFORMATION
ƈYou can charge the rechargeable battery (SLB-0837B) by using an SAC-45 KIT.
The SAC-45 consists of the AC adapter (SAC-45) and the USB cable (SUC-C2).
When the AC adapter and the USB cable are assembled, it can be used as an
AC cable.
ƃUsing the SAC-45 as an AC charger
: Insert the AC adapter into the USB connector.
When the AC adapter is inserted, it can be used
as an AC charger.
ƃUsing the SAC-45 as an USB cable
: Remove the AC adapter from the USB connector.
You can transmit data with a PC (p.45) or charge
the battery.
In the following cases, the battery may not be charged.
ƃWhen using the USB cable that was not supplied with this camera : Use the
supplied USB cable.
ƃWhen using the USB hub : Connect the camera to the PC directly.
ƃWhen other USB devices are connected to the PC : Disconnect the other
USB devices.
ƃWhen the USB is connected to the USB port located on the front of the
computer : Use the USB located on the back of the computer.
ƃ
If the USB port of the PC doesn't meet the Power output standard (5V, 500mA),
the camera may not be charged.
CAUTION