Filter
Top Products
English – 11
ENG
Installation
n
Installing on a pipe
Before installation, you have to be familiar with the above cautions and fi ll in the holes that
are not used for installation.
To install your camera bottom on a pipe
1.
After connecting the power and video cables,
throw them inside the pipeline and screw the male
thread pipe into the female pipe thread in your
camera tightly to fix the
Main body
. (In this case,
be sure to tape with Tefl on tape before assembly for
waterproofi ng. Be careful for the wiring cable not to
be stuck in the connection area.)
2.
Adjust the angle of the camera in search of a better
view.
1)
Separate the Dome cover using the L-Wrench
provided. (To make loose the screws, rotate
counterclockwise.)
2)
Adjust the lens direction. For more information,
see page 17 “Adjusting the camera direction.”
3.
Attach the Dome cover. (Screw the connection bolts
tightly using the L-Wrench for waterproofi ng.)
To change the SAMSUNG logo position, move the
location of the connection rubber band as show
below and rotate for assembly. (The rotation limit
is 180 degree.)