Filter
Top Products
10
11
❚
Connecting cables and changing the settings
Before installing your camera, you have to adjust the lens focus, zoom, and switch settings.
To connect cables
1. Connect the BNC cable
to the Video connector
attached on your camera.
2.
Connect the BNC cable
to the Video Input on a
monitor.
3.
Connect the power adapter
to the Power connector
attached on your camera.
When the monitor is turned
on, the camera image
appears.
To adjust the lens focus, zoom, and function settings
1. Remove the Cover dome and Inner cover. For more details about the removing procedures,
see “Installation procedure,” in the Installing camera section on the next page.
2.
Adjust the focus, zoom, and function settings of your camera using the Focus lever, Zoom
lever, and Switch board while you are viewing the image on the screen.
3.
If you want to x the adjusted focus and zoom, screw up the levers.
BNC Cable
Monitor
B5344_B5345-00687D(00).indb 10 2008-09-05 오전 10:40:25