Filter
Top Products
Version 1.1
- 18 -
-
BURST
:
If set to
<
OFF>,theburstsignalwillnotbe
output in NIGHT mode.
-
DAY
→
NIGHT BRIGHTNESS
:
Specify the brightness level
switching from COLOR to BW filter. Adjusting from HIGH
toLOWwillcausetoswitchthefilterin
a
darker screen.
-
DAY
→
NIGHT DWELL TIME
:
Time required to determine
the filter switch.
-
NIGHT
→
DAY BRIGHTNESS
:
Specify the brightness level
switching from BW to COLOR filter. Adjusting from HIGH
toLOWwillcausetoswitchthefilterin
a
darker screen.
-
NIGHT
→
DAY DWELL TIME
:
Time required to determine
the filter switch.
-
MASK AREA
:
If there exists
a
bright spot light source in
a
night scene, you can specify the size and position as
needed. This will prevent an error in switching filter, or
failure to determine the filter switch in
a
night scene
where
a
bright spot light source exists.
Any excessively bright area in
a
night scene will be
masked.
※
You can specify MASK
1
and
2
simultaneously.
※
If
<
BACKLIGHT> is set to
<
BLC>, the MASK AREA
function is not available.
●
WHITE BAL
If you need to adjust the color according to the ambient
illumination, you can use the
<
WHITE BAL> function.
-
DAY
:
You can set the RED, and BLUE value in DAY
mode. The screen will be displayed in colors according
to your settings.
You can set the R-GAIN, and B-GAIN value only in
<
AWC> mode.
-
NIGHT
:
You can set the
<
WHITE BAL> according to the
ambient illumination. If NIGHT mode is set to
<
OFF>,
the
<
WHITE BAL> will operate in
a
mode specified in
DAY mode at all times; otherwise, the screen will switch
to
a
mode specified in
<
DAY/NIGHT>.
You can set the RED, BLUE and BRIGHTNESS value in
DAY mode. The screen will be displayed in colors
according to your settings.