Filter
Top Products
COLOR CCD CAMERA User’s Manual
41
COLOR CCD CAMERA User’s Manual
40
Problem
Nothing appears on
the screen.
The image on the
screen is dim.
The image on the
screen is dark.
The camera is not working
properly, and the surface
of the camera is hot.
The DAY/NIGHT menu
does not work.
The SENS-UP function
does not work.
Solution
• Check that the power cord and line connection
between the camera and monitor are fixed properly.
• Check that you have properly connected VIDEO
cable to the camera VIDEO output jack.
• Is lens stained with dirt? Clean your lens with soft,
clean cloth.
• Set the monitor to proper condition.
• If the camera is exposed to too strong light, change
the camera position.
• Adjust the contrast feature of the monitor.
• If you have an intermediate device, set the 75Ω / Hi-z
properly.
• Check that you have properly connected the camera
to an appropriate power source.
• Check that AGC of EXPOSURE SETUP menu is
‘OFF’.
• Check that AGC of EXPOSURE SETUP menu is
‘OFF’.
• Check that SHUTTER of EXPOSURE SETUP menu is
‘A.FLK’ or ‘MANUAL’.
If you have trouble operating your camera, refer to the following table.
If the guidelines do not enable you to solve the problem, contact an authorized
technician.
Troubleshooting
Press the SET button in the EXIT menu to save the current settings and exit the SET menu.
EXIT
LANGUAGE : You can select the menu language according to your requirements.
RESET : Resets the camera settings to the factory defaults.
RETURN : Select this to save the SPECIAL menu settings and return to the SPECIAL
menu.
- CAM ID : Determines the camera's identification number (between 0 and 25).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device
when a communication control command is sent to the camera.
- DISP CAM ID : Display camera title on top left corner of the screen.
DIS (Digital Image Stabilizer) :
This function mitigates any picture movement due to external factors such as wind.
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication
status when controlling the camera through an
external control device.
When the SPECIAL menu screen is displayed,
press the Up and Down buttons so that the
arrow indicates ‘COMM ADJ’.
Set up the mode using the 4 direction buttons.
How to Use the Camera
- MASK COLOR : Determine area color. You can select Gray, Green, Red, Blue, Black,
White.
- TRANSP : Determine the transparency of selected area as controlling number from 0 to 3.
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL
menu.