Filter
Top Products
P/No. : Z6806-0715-01A
VAN 06. 03
This installation should be made by a qualified service person and should conform to all local codes.
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to
alert the user to the presence of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the appliance.
INFORMATION-This equipment has been tested and found to comply with limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will required to correct the interference at his own expense.
WARNING-Changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
WARNING - To prevent electric shock and risk of fire hazards:
Do NOT use other than specified power source.
Do NOT expose this appliance to rain or moisture.
PRECAUTIONS GETTING TO KNOW YOUR CAMERA
FEATURES
Do not install the camera in extreme
temperature conditions.
Only use the camera under conditions where
temperatures are between -10˚C and +50˚C.
Be especially careful to provide ventilation
when operating under high temperatures.
Do not install or use the camera in an
environment where the humidity is high.
It can cause the image quality to be poor.
Do not touch the front glass of the
camera.
It is one of the most important parts of camera.
Be careful not to be stained by fingerprint.
Never keep the camera face to strong
light directly.
It can damage the CCD.
Do not drop the camera or subject
them to physical shocks.
It can cause malfunctions to occur.
Do not expose the camera to rain or
spill beverage on it.
If it gets wet, wipe it dry immediately.
Liquids can contain minerals that corrode the
electronic components.
Never use the camera close to a gas
or oil leak.
It can cause malfunctions to occur.
Do not install the camera under
unstable lighting conditions.
Do not disassemble the camera.
There are no user-serviceable parts inside it.
Severe lighting change or flicker can cause
the camera to work improperly.
• If the camera is exposed to spotlight or object reflecting the strong light, smear or blooming may occur.
• Please check the power whether it satisfies the normal specification before connecting the camera.
Notes
Horizontal Resolution 540 TV Lines
Clear image quility has been achieved by employing a CCD with 410,000 pixels(NTSC), 470,000
pixels(PAL) and optimized WINNER3 DSP CHIP which provides a horizontal resolution of 540 TV lines.
High Sensitivity
The built-in high sensitivity COLOR CCD enables a clear image even in 0.05Lux or lower illumination.
SSNR (Samsung Super Noise Reduction)
By using built-in SSNR function manufactured by SAMSUNG TECHWIN, the amount of low illuminance
noise has been significantly reduced, and the signal-to-noise ratio (S/N) as well as horizontal resolution
have been improved, resulting in a clear and sharp image display even in the dark.
Pan and Tilt
Pan and tilt are available after installing camera.
MINI DOME CAMERA USER’S MANUAL
7
MINI DOME CAMERA USER’S MANUAL
6
MINI DOME CAMERA USER’S MANUAL
2
MINI DOME CAMERA USER’S MANUAL
3
MINI DOME CAMERA USER’S MANUAL
5
MINI DOME CAMERA USER’S MANUAL
4
www.samsungtechwin.com
www.samsungcctv.com
•
SAMSUNG TECHWIN CO., LTD.
145-3, Sangdaewon 1-dong, Jungwon-gu, Seongnam-si,
Gyeonggi-do 462-703, Korea
TEL: +82-31-740-8137~8141 FAX : +82-31-740-8145
•
SAMSUNG OPTO-ELECTRONICS UK, LTD.
Samsung House, 1000 Hillswood Drive, Hillswood
Business Park Chertsey, Surrey KT16 OPS
TEL: +44-1932-45-5308 FAX : +44-1932-45-5325
•
TIANJIN SAMSUNG OPTO-ELECTRONICS CO., LTD.
7 Pingchang Rd, Nankai Dist. Tianjin 300190, P.R China
TEL: +86-22-2761-4724(33821) FAX : +86-22-2761-6514
SALES NETWORK
SID-50
HIGH RESOLUTION MINI DOME CAMERA
INSTRUCTION MANUAL
About this manual
Before installing and using the camera, please read this manual carefully. Be sure to keep it handy for later reference.
Thank you for purchasing a SAMSUNG CCD CAMERA.
Before operating the camera, confirm the camera model and proper input power voltage. In
order that you can understand this manual thoroughly, we'll introduce our model description.
SID-50 SERIES
• NTSC models • PAL models
SID-50N SID-50P
Model Description
• SID-50X • SIGNAL SYSTEM
N NTSC Model
P PAL Model
Signal system
WARNING
The camera needs periodic inspection.
Contact an authorized technician for inspection.
Stop using your camera when you find a malfunction.
If you use your camera around smoke or unusual heat for a long time, a fire
may be caused.
Do not Install the camera on a surface that can not support it.
Unless the surface is suitable, it could cause falling or other hazards.
Do not handle the camera with wet hands
It could cause an electric shock.
Pan Base
You can rotate the lens
from 360˚
Tilt Base
You can adjust up and
down the camera(20°~90°).
Front
Power Input Terminal
BNC Jack
Bottom