Filter
Top Products
Operating Your Camera
COLOR CCD CAMERA User’s Manual
37
COLOR CCD CAMERA User’s Manual
36
Press the SET button in the EXIT menu to save the current settings and exit the SET menu.
EXIT
LANGUAGE : You can select the menu language according to your requirements.
RESET : Resets the camera settings to the factory defaults.
RETURN :
Select this to save the SPECIAL menu settings and return to the SPECIAL menu.
- CAM ID : Determines the camera's identification number (between 0 and 25).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device
when a communication control command is sent to the camera.
- DISP CAM ID : Display camera title on top left corner of the screen.
COMM ADJ (Communication Adjustment):
This function sets up the camera communication status when controlling the
camera through an external control device.
When the SPECIAL menu screen is displayed, press the Up and Down buttons
so that the arrow indicates ‘COMM ADJ’.
Set up the mode using the 4 direction buttons.
Refer to the following table if you are experiencing trouble with your camera.
Contact an authorized technician if the table does not provide you with a
solution to the trouble.
Troubleshooting
Problem
Nothing appears on
the screen.
The image on the
screen is dim.
The image on the
screen is dark.
The camera is not working
properly, and the surface
of the camera is hot.
The DAY/NIGHT menu
does not work.
The SENS-UP function
does not work.
Solution
• Check that the power cord and line connection
between the camera and monitor are fixed properly.
• Check that you have properly connected VIDEO
cable to the camera VIDEO output jack.
• Is lens stained with dirt? Clean your lens with soft,
clean cloth.
• Set the monitor to proper condition.
• If the camera is exposed to too strong light, change
the camera position.
•Adjust the contrast feature of the monitor.
• If you have an intermediate device, set the 75Ω/ Hi-z
properly.
• Check that you have properly connected the camera
to an appropriate power source.
• Check that AGC of EXPOSURE SETUP menu is
‘OFF’.
• Check that AGC of EXPOSURE SETUP menu is
‘OFF’.
• Check that SHUTTER of EXPOSURE SETUP menu is
‘A.FLK’ or ‘MANUAL’.