Filter
Top Products
English-2-21
2-9) Local System Configuration
1. Connect LAN cable of Cable/DSL modem or Direct Fixed/Static IP LAN Line to WAN port of IP Router.
2. Connect LAN ports of IP Router(1~4 or 1~8) to Ethernet port SMO-210DN to be set up and to Ethernet port of
Local PC to use during setup.
3. Connect Video cable of Camera to MONITOR.
4. Turn on the MONITOR power.
Notice
If you have a Static (Fixed) IP line or Dynamic IP line (Cable Modem or DSL Modem) with one IP address
(whether its dynamic or fixed), but have more than one internet device to use (such as a PC and a SMO-210DN
or several); you must use an IP Router (different from a simple Network Hub); you must set up the Router to
work with the SMO-210DN and you must use a network capable PC within the local Router network to do the
setup.
If you are using an existing Router which is already set up, you may not need to redo the basic setup of the
Router again, but it is highly recommended that you at least read all the instructions on the following pages and
go through the steps.Whether you are using an existing Router or a new Router, you must go through the Port
Forwarding portion of the setup.