Filter
Top Products
11
English
Push the release lock out while turning the main unit in the
<UNLOCK> direction to remove the bracket.
If this doesn't work, use the hole on the bottom of the
bracket to turn the bracket in the <LOCK> direction.
Use the provided screws (x3) to fix the bracket to a
desired position (ceiling or wall).
Ensure that the <CAMERA FRONT> label on the bracket faces the
direction for camera monitoring.
Arrange the cables through the bracket to the ceiling or
wall.
Press hard the upper lid down to remove it before you can
arrange the cables through to the ceiling.
If you do not intend to install the camera on the ceiling, use
the opposite empty area to the <CAMERA FRONT> label side for the wiring.
Mount the main unit onto the bracket.
Align the marking hole of the main unit with the <CAMERA FRONT> label of the bracket,
and turn the unit in the <LOCK> direction.
Adjust the lens in a desired direction.
For adjusting the lens direction, refer to "Adjusting the monitoring direction for the
camera".
Secure the inner cover to the main unit.
Fit the two holes of the wing-side locks on the inner cover into the corresponding hole
of the main unit, and press it down until you hear a click.
Fix the cover to the main unit.
Fit the protruding part inside the cover into the corresponding hole of the main unit, and
turn the cover to fix it.
3.
4.
5.
6.
7.
8.
9.
Upper Lid
SNC-B5368-ENG-QG.indd 11 2009-08-19 오후 8:42:32