Filter
Top Products
4
Inside
Item Description
Alarm I/O Port
Consists of two different ports:
- ALARM IN : Used to receive the alarm input signal.
- ALARM OUT : Used to output the alarm output signal.
- GND : Used for earth-grounding.
Reset Button
Restores all camera settings to the factory default. Press and hold it for about 3
seconds to turn off the system indicator and restart the system.
J
After resetting the camera, you must run the IP Installer program to change
the basic network settings such as IP address, Subnet mask, Gateway, etc.,
before you can connect to the network.
SNC-B5368-ENG-QG.indd 4 2009-08-19 오후 8:42:00