Filter
Top Products
English _21
● OVERVIEW
Item Description
a
Lens Lens for the camera.
b
Alarm I/O Port
ALARM IN Used to connect the alarm input signal.
ALARM OUT Used to connect the alarm output signal.
GND Used for earth-grounding.
c
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
d
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
e
Focus Adjustment
Button
The button adjusts the focus of image automatically.
f
SD Memory Card
Compartment
Compartment for the SD memory card.
g
Lock Release Lever
Press the <UNLOCK> levers on both ends to separate camera module from
the body.
h
Bracket Used to install the camera on the wall or ceiling with the screws.
i
Wiring Cover
If you drill a hole in the wiring cover for wiring,
remove the cover and attach the provided
dustproof plate to it, and arrange the cables
through the plate.
j
Release Lock
If you want to remove the bracket from the main unit or remove the camera
from the bracket, push this out and turn the main unit in the <UNLOCK>
direction.