Filter
Top Products
English _33
● INSTALLATION & CONNECTION
To add an alarm cable (not included)
1. For this, first you should remove the top cover
from the housing.
2. Pull out the protruding rubber bar as shown.
3. This will reveal a hole in the place of the rubber
bar, through which you insert the cable, and
connect it to the alarm terminal on the PCB.
4. Connect and arrange the necessary cables
(power, video, etc) lest that they should be
damaged or caught while installing the camera.
Then, install the camera assembly in the reverse
order of the disassembly.
5. Refer to “Adjusting the monitoring direction
for the camera” to adjust the lens in a desired
direction.
(page 38)
6. Close the top cover.