Filter
Top Products
Operating Your Camera
WHITE BALANCE CONTROL
Your camera provides three 'WHITE BAL' control modes for your choosing in
adjusting the white balance.
1. Press the SET button to access the main setup menu and move the indicator
to 'WHITE BAL' using the UP or DOWN button.
2. Set 'WHITE BAL' using the LEFT or RIGHT button.
The three white balance control modes are as follows :
ATW(Auto Tracking White Balance):
• OUTDOOR: This mode can be used within the color temperature range 1800~10500˚K
(Ex: fluorescent light, outdoor, sodium vapor lamp or inside tunnels)
• INDOOR : This mode can be used within the color temperature range 3000K~10500˚K.
AWC(Auto White balance Control):
The white balance is automatically adjusted in a specific environment. In order to
obtain the best result, press the SET button while the camera focuses on white
paper. If the environment including the light source is changed, you have to adjust
the white balance again.
Manual:
To fine adjust, select the Manual mode. You can increase or decrease the red or
blue factor while monitoring the difference on the screen. Set to 'MANUAL' mode
and press the SET button. Increase or decrease the value for red(R-Gain) and
blue(B-Gain), watching the color of the picture, and press the SET button when you
obtain the best color.
COLOR CCD CAMERA User’s Manual
21
COLOR CCD CAMERA User’s Manual
20
MAIN SETUP
CAM TITLE OFF
WHIET BAL ATW
BACKLIGHT OFF
MOTION DET OFF
FOCUS
EXPOSURE
5. Select on screen position of the CAM TITLE.
Move the cursor to 'POS' and press SET button.
The CAM TITLE is displayed on the top-left of the monitor screen.
(Default position)
Select the position by using the 4-directional buttons, then press the SET
button to confirm the position.
6. When completed, move the cursor to 'END' and press SET button.
to Locate, then SETto Locate, then SET
FRONT DOOR
to Locate, then SET
FRONT DOOR