Filter
Top Products
PARTS NAMES
8 Lens iris output connector (4 pin)
This 4-pin connector is used to send the DC control signal
and power supply to an auto-iris type lens.
9 Camera setup section (under the cover)
This unit factory settings are as indicated below. These
settings are for when using a 1/2 inch CS mount DC
(without EE internal amplifier) type lens. However, if due to
installation conditions or environment the settings may need
to be modified for best results (see "SETTINGS"). To access
the controls, remove the cover fixing screw, then remove the
cover.
Control name Position
a
High speed electronic shutter
switches (E.S.)
All OFF: 1/60 sec
b
Electronic iris (EI)/
Backlight compensation (BLC)
switch
OFF
c