Filter
Top Products
MOUNTING THE LENS
Pin layout
1 Brake coil (–)
2 Brake coil (+)
3 Drive coil (+)
4 Drive coil (–)
Rewiring the lens cable in the lens iris plug
1 Prepare the lens cable.
Cut the cable at the plug, then remove approx. 8 mm of the cable sheath and
strip about 2 mm from each wire.
2 Install the lens iris plug.
Solder the cable to the pins following the correct pin layout (refer to the
table and illustrations), then close the plug cover.
Compatible auto-iris lenses (1/3 inch COSMICAR DC type lens)
• Standard angle, f= 8 mm (TS812E Equivalent)
• Wide angle, f= 4 mm (TS412E Equivalent)
• Ultra-wide angle, f= 2.8 mm (TS212E Equivalent)
1
2