Filter
Top Products
PARTS NAMES
9
Lens iris output connector (LENS)
This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.
F
Camera setup section (under the cover)
These settings are for when using a 1/3 inch CS mount
DC
(without
EE
internal amplifier) type lens. However,
if due to installation conditions or environment the settings may need to be modified for best results (see
"
SETTINGS
"). To access the controls, remove the cover fixing screw, then remove the cover.
NOTE:
When using a 1/2 or 2/3 inch C mount
VIDEO
(with
EE
internal amplifier) auto-iris type lens, set the
A.I. LENS
switch to the
VIDEO
position.
F
9
L53H4/US2 (VCC-5984) GB 2003, 1, 7
6
English