Sanyo VCC-MD500 Security Camera User Manual


 
− 40 −
2006.12.20: the issue of ver 1.00
2007.02.15: the issue of ver 1.01
Changes the DEFAULT communication speed (BAUDRATE) of the MD800 – 500 to 9600 bps.
Newly added commands.
Cover Offset OFF/ON
Cover Offset Level
Auto Focus Mode during pan/tilt
ATW Mask Display
Center BLC Area Display
BLC Mask Display
Motion Size Display
Motion Mask Display
D/N Filter Slide Time
Status type 7
Status type 8
Newly added stabilizer function command and function description (only MD700/800 can be used).
Newly added auto pursuit function command and function description.
Newly added exclusive processing note.
Newly added focus lens offset function description.
Newly added icon of application software and description postscript.
Revised privacy mask setting note.
Revised power source, power consumption specifications.
2007.05.10: the issue of ver 1.02
Newly added commands.
OSD setting command (MD500 – 800 only)
Camera ID setting command
Area Mask Position Full Screen Set (MD 500-800 only)
Mask Area Center Position (MD 500-800 only)
The privacy mask maximum setting value has been increased from 8 to 15. (MD 500-800 only)
The tilt degree range of the Privacy Masking, Pan/Tilt Degree command has been expanded to: –180 to 180
degrees. The related commands and instructions have been revised. (MD500-800 only)
Newly added angle area to the specifications of each model.
2007.06.19: the issue of ver. 1.03
Newly added commands.
Zoom Direct with Focus (MD500 – 800 only)
Change in required time from Wide end
Tele end
2007.11.01: the issue of ver.1.04
Add new commands below:
Pixel defect compensation command.
Auto pixel defect compensation command at start-up.
Revise Zoom Direct with Focus command.
Add exclusive processing table.
Add method of model distinguishing.
Add Smart ATW description.
Add info regarding time-period of accepting the commands after start-up.
Add notices below:
Pixel defect compensation function
Auto pursuit function
Change history