Filter
Top Products
¡0 FixingandRemovingtheLens
The lens is available in a connection socket to match different 35 mm SLR
camera systems and is inserted into the camera bayonet or thread for fas-
tening to the camera such that the red dot on the connection socket is op-
posite the corresponding marking on the camera
To lock the lens in the bayonet or thread and to release it again, the lens
should be rotated at the knurled ring and not at the tube since the latter is
not rigidly connected to the bayonet or thread due to the rotary mount
and since there is therefore a risk that the tube will turn without the bayo-
net or thread engaging and tightening up to the stop
The camera mount of the lens is fastened using Phillips screws and can be
replaced to match the new camera on a change of the camera system The
user can make the retting him or herself using a size zero Phillips screw-
driver The table on page ¡5 shows the camera systems for which camera
mounts can be obtained and gives their order numbers
ReplacingtheMountforaDifferentCamera