SmartDisk Secure Digital Memory Card Camera Accessories User Manual


 
FlashPath User Guide
16
Safety
• • • • • •
Safety
For maximum safety, please observe the following warnings and cautions.
WARNINGS
Incorrect handling and/or operation could cause serious injury.
When handling batteries:
Keep the batteries out of the reach of small children. If swallowed, poisoning or
asphyxiation can result. Seek medical treatment immediately.
Do not combine old and new batteries.
Do not disassemble, modify, repair or charge the batteries.
Do not connect the positive and negative terminals with any metal such as wire.
Do not transport or store batteries together with metallic objects.
Do not heat batteries or directly expose them to fire.
Do not drive nails into, strike with a hammer, or step on the battery. Failure to observe
the above could result in battery leaks, heat emission, ignition, rupturing, skin burns or
other injury.
Observe the positive and negative polarity indications when inserting the batteries. Do
not allow dead batteries to remain in the battery compartment. Failure to observe the
above could result in battery leaks, heat emission, rupturing, skin burns or other kind of
injury.
If leaking occurs, do not allow battery fluid to come in contact with the skin. Doing so
could result in skin burning. If battery fluid gets on your skin or clothes, wash
immediately with water. If battery fluid gets in your eyes, flush with water and seek
medical treatment immediately.
Use only the recommended type of batteries. Failure to do so could result in battery
leaks, heat emission, rupturing, skin burns or other kind of injury.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to
the manufacturer’s instructions.
117-0005-010
CAUTIONS
Incorrect handling and/or operation could cause damage to equipment or files.
Do not use FlashPath near sources of heat or flame. Doing so could result in smoke or
fire.
Do not immerse FlashPath in liquids such as water, chemicals or oil. Doing so could
result in short circuiting, electric shock or fire.
If bent, dropped or exposed to strong impact, the product should be inspected at the
place of purchase or by SmartDisk.
Failure to do so could result in smoke or fire.