Sony 100 Security Camera User Manual


 
5
Note on the battery pack
Use only an NP-FM55H battery pack. Note that the NP-FM50 and NP-FM30 cannot be used.
Using the AC Adaptor/charger
You can connect the camera to a wall outlet (wall socket) using the AC-VQ900AM
AC Adaptor/charger (not supplied).
t “User’s Guide/Troubleshooting” (page 144)
To check the remaining battery level
Set the POWER switch to ON and check the level on the LCD monitor.
To remove the battery pack
Slide the lock lever in the direction of the arrow. Be careful not to drop the battery pack.
Before removing the battery pack, check that the power is turned off.
To use your camera abroad — Power sources
You can use your camera and the battery charger and the AC-VQ900AM AC Adaptor/charger
(not supplied) in any country or region where the power supply is within 100 V to 240 V AC,
50/60 Hz. Use a commercially available AC plug adaptor [a], if necessary, depending on the
design of the wall outlet (wall socket) [b].
Battery
remaining
indicator
(white) (white) (white) (red)
Battery
exhausted.
Battery
remaining
guidelines
Sufficient
power
remaining
Battery half
full
Battery low,
recording/
playback will
stop soon.
Change the
battery pack
with fully
charged one,
or charge the
battery pack.
The shutter
will not be
released.
Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
Lock lever