Filter
Top Products
35
CCD-TR78/TR88/TR98 3-810-917-13.E
Tips for Using the Battery Pack
Playback Modes/Tips for Using the Battery Pack
When the remaining battery indicator reaches the lowest point, the i indicator appears and starts
flashing in the viewfinder.
When the i indicator in the viewfinder disappears and the battery lamp flashes rapidly, turn the
POWER switch to OFF on the camcorder and replace the battery pack. Leave the tape in the camcorder to
obtain smooth transition between scenes after the battery pack has been replaced.
Note on the remaining battery indicator
The remaining battery indicator of the camcorder may indicate a different remaining capacity from
that of the battery pack with the remaining battery indicator (not supplied). The indicator of the
battery pack is more accurate.
Notes on the Rechargeable Battery Pack
Caution
Never leave the battery pack in temperatures above 140°F (60°C), such as in a car parked in the sun
or under direct sunlight.
The Battery Heats Up
During charging or recording, the battery pack heats up. This is caused by energy that has been
generated and a chemical change that has occurred inside the battery pack. This is not cause for concern
and is normal.
Battery Pack Care
•Remove the battery pack from the camcorder after using it, and keep it in a cool place. When the
battery pack is installed to the camcorder, a small amount of current flows to the camcorder even if
the POWER switch is set to OFF. This is shortens battery life.
•The battery pack is always discharging even when it is not in use after charging. Therefore, you
should charge the battery right before using the camcorder.
How to Use the Switch on the Battery Pack
When the switch is supplied with the battry pack ([a] on p. 36) you can use it to find whether the
battery pack is charged or not. Set the switch to the “no mark” position when charging is completed.
Set the switch to the “red mark” position when the battery is used up (or in whichever direction you
want to remind yourself).
The Life of the Battery Pack
If the battery lamp flashes rapidly just after turning on the camcordrer with a fully charged battery
pack, the battery pack should be replaced with a new fully charged one.
Charging Temperature
You should charge batteries at temperatures from 50°F to 86°F (from 10°C to 30°C). Lower
temperatures require a longer charging time.
Sony Batteries are Recommended
Use of non-Sony batteries may damage your Handycam camcorder.