Filter
Top Products
91
Additional information Дополнительная информация
Trouble check
Picture
Symptom Cause and/or Corrective Actions
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 19)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 9, 30)
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least 1
hour. (p. 83)
• You pressed DATE and TIME together for more than 2
seconds.
m The camcorder is not malfunctioning. You may start
recording. Flashing will stop soon.
• The lithium battery is weak or dead.
m Replace the lithium battery with a new one. (p. 73)
• The POWER switch is set to CAMERA or OFF.
m Set it to VTR.
• The tape has run out.
m Rewind the tape or use a new one. (p. 26)
• STEADYSHOT is set to OFF.
m Set it to ON. (p. 68)
• The Steady Shot function does not work when the wide mode
is set to 16:9 FULL.
• FOCUS is set to MANUAL.
m Set it to AUTO. (p. 57)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANUAL to focus manually. (p. 57)
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 19)
• The DIGITAL EFFECT function is working. (CCD-TRV55E
only)
m Cancel it.
• The stereo tape is played back with HiFi SOUND set to 1 or 2 in
the menu system.
m Set to STEREO in the menu system. (p. 37)
• The picture has been recorded with WIND set to ON in the
menu system.
m When there is no wind, set it to OFF. (p. 35)
• Reset the date and time. (p. 75)
Recording stops in a few seconds.
The date or time indicator
disappears.
Excessive high-pitched sound is
heard.
The fader function does not work.
The autofocusing function does not
work.
The Steady Shot function does not
activate.
The tape does not move when a
video control button is pressed.
No sound or only a low sound is
heard when playing back a tape.
The date or time indicator is flashing.
{ and 6 indicators flash and no
function except for cassette ejection
works.
The cassette cannot be removed from
the holder.
Symptom Cause and/or Corrective Actions
• The viewfinder lens is not adjusted.
m Adjust the viewfinder lens. (p. 15)
The image on the viewfinder screen
is not clear.
(to be continued)