Filter
Top Products
80
Replacing recording on a tape – Insert Editing
– CCD-TRV99 only
You can insert a new scene from a VCR onto your originally recorded tape by
specifying starting and ending points.
Connections are the same as in “Recording from a VCR or TV”.
(1) While pressing the small green button on the POWER switch, set it to VTR.
(2) On the VCR, locate the start point to be inserted and set it to playback pause
mode.
(3) On the camcorder, locate the point where the insert should end by pressing
0 or ), then press P to set it to playback pause mode.
(4) Press COUNTER RESET to set the counter to zero.
(5) On the camcorder, locate the point where the insert should begin by pressing
0, then press r REC and P to set it to recording pause mode.
(6) Press ZERO MEM. The ZERO MEM indicator flashes and the end point of the
insert is stored in memory.
(7) Press P on the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the zero point on the counter.
To change the end point
Press ZERO MEM so that the ZERO MEM indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.
Recording from a VCR or TV