Sony CLMV55 Camera Accessories User Manual


 
20-GB
Note
When this unit is connected to the camera by the HDMI cable, the following
may happen depending on the camera.
No image appears on the camera’s LCD screen.
The camera switches to playback mode. (Make sure the camera is in shooting
mode before taking pictures.)
Tip
After a certain time in either of the following conditions, the backlight of this
unit turns off.
No HDMI signal is output from the camera
The HDMI cable is disconnected
Carrying out the following turns the backlight on again.
Press the operation dial of this unit.
Operate the camera so that an HDMI signal is output.
Reconnect the HDMI cable and turn the camera on.
To remove from the camera
Disconnect the HDMI cable and remove this unit as below.
Note
When removing, be careful not to drop this unit or the camera. It is
recommended that you attach the camera to a tripod before removing
this unit.
When using an auto lock accessory shoe:
Push the lock lever of the shoe adaptor down to the left to release the lock.
Keeping the lock lever pressed to the left, slide the shoe adaptor toward you.