Filter
Top Products
94
DCR-PC1000E 2-591-679-11(1)
No sound or only a low sound is heard.
• Set [MULTI-SOUND] to [STEREO] (p. 54).
• Turn up the volume (p. 23).
• Adjust [AUDIO MIX] from the [ST2/REAR] (additional sound) side until the sound is heard
appropriately (p. 68).
• When you are using an S VIDEO plug, make sure the red and white plugs of the A/V
connecting cable are connected as well (p. 34).
The sound breaks off.
• Clean the head using the cleaning cassette (optional) (p. 113).
“---” is displayed on the screen.
• The tape you are playing was recorded without setting the date and time.
• A blank section on the tape is being played.
• The data code on a tape with a scratch or noise cannot be read.
Noises appear and is displayed on the screen.
• The tape was recorded in a TV color system other than that of your camcorder (PAL). This is
not a malfunction (p. 106).
Date Search does not work correctly.
• If one day’s recording is less than 2 minutes, your camcorder may not accurately find the
point where the recording date changes.
• There is a blank section in the beginning or middle of the tape. This is not a malfunction.
Remote Commander
The supplied Remote Commander does not function.
• Set [REMOTE CTRL] to [ON] (p. 57).
• Remove any obstructions between the Remote Commander and the remote sensor.
• Point the remote sensor away from strong light sources such as direct sunlight or overhead
lighting. Otherwise, the Remote Commander may not function properly.
• Insert a new battery. Insert a battery into the battery holder with the +/– polarities correctly
matching the +/– marks. (p. 115).
• Remove the conversion lens (optional) as the remote sensor may be obstructed by it.
Another VCR malfunctions when you use the supplied Remote Commander.
• Select a commander mode other than VTR 2 for your VCR, or cover the sensor of your VCR
with black paper.
Troubleshooting (Continued)