Sony DCR-PC7 Camcorder User Manual


 
91
DCR-PC7.3-858-174-22 (E,S)
Additional information / Información adicional
Indicadores de aviso
Warning indicators
213
456
789
If indicators flash on the LCD screen or in the
viewfinder or warning messages appear on the
display window , check the following:
: you can hear the beep sound when BEEP is
set to ON in the menu system.
1 The battery is weak or dead.
Slow flashing: The battery is weak.
Fast flashing: The battery is dead.
Depending on conditions, the i indicator
may flash, even if there are 5 to 10 minutes
remaining.
2 The tape is near the end.
The flashing is slow.
3 The tape has run out.
The flashing becomes rapid.
4 No tape has been inserted.
5 The tab on the tape is out (red).
6 Moisture condensation has occurred. (p. 66)
7 The video heads may be contaminated.
(p. 67)
8 The clock is not set.
If the clock is not set when you press START/
STOP button in the CAMERA mode, the
message appears for 5 seconds.
9 Some other trouble has occurred.
Disconnect the power source and contact your
Sony dealer or local authorized facility.
5min
0min
Si parpadean indicadores en la pantalla LCD o en
el visor electrónico o si aparecen mensajes de
aviso en el visor principal, compruebe lo
siguiente:
: el pitido puede oírse cuando BEEP está
ajustado en ON en el sistema de menús.
1 La batería está débil o agotada.
Parpadeo lento: La batería está débil.
Parpadeo rápido: La batería está agotada.
El indicador i puede parpadear,
dependiendo de las condiciones, incluso si el
tiempo restante es de 5 a 10 minutos.
2 La cinta se acerca al final.
El parpadeo es lento.
3 Se ha terminado la cinta.
El parpadeo es más rápido.
4 No se ha insertado ninguna cinta.
5 La lengüeta de la cinta está fuera (roja).
6 Hay condensación de humedad. (p. 66)
7 Es posible que los cabezales de vídeo estén
contaminados. (p. 67)
8 El reloj no está ajustado.
Si el reloj no está ajustado y pulsa el botón
START/STOP en el modo CAMERA, aparece
el mensaje durante 5 segundos.
9 Ha surgido algún otro problema.
Desconecte la fuente de alimentación y
póngase en contacto con el proveedor Sony o
un servicio técnico autorizado local.