Filter
Top Products
53
Editing on Other Equipment
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator and begin from step 3.
Notes
•The zero set memory function works only for tapes recorded in the Digital8 system.
•The picture and sound recorded on the section between the insert start and end points
will be erased when you insert the new scene.
When the inserted picture is played back
The picture may be distorted at the end of the inserted section. This is not a
malfunction.
To insert a scene without setting the insert end point
Skip step 3 and 4. Press p when you want to stop inserting.
Inserting a scene from a VCR
(1)Set the POWER switch to VTR.
(2)On the VCR, locate just before the insert start point [a], then press P to set the VCR
to the playback pause mode.
(3)On your camcorder, locate the insert end point [c] by pressing 0 or ). Then
press P to set it to the playback pause mode.
(4)Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY
indicator flashes and the end point of the insert is stored in memory.
(5)On your camcorder, locate the insert start point [b] by pressing 0, then press
two r REC buttons at same time to set your camcorder to the recording pause
mode.
(6)First press P on the VCR, and after a few seconds press P on your camcorder to
start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically returns to the recording pause mode.
4
0:00:00
ZERO SET
MEMORY
ZERO SET
MEMORY
5
REC