Sony DPF-D830L Digital Photo Frame User Manual


 
11
GB
Let’s get the photo frame ready
Let’s get the photo frame ready
Remote control
Pull out the protective sheet before use as shown in the
figure.
Using the remote control
Point the top end of the remote control towards the remote sensor on
the photo frame.
Stand
1 Push on the v mark on the stand in the direction of
arrow
A and slide the stand in the direction of arrow B
until it stops, as illustrated below.
2 Extend the stand by holding the lower part of the stand
then place it on a flat surface.
You can adjust the angle of the stand.
Protective sheet
P Notes
If the remote control stops
working:
Replace the battery (CR2025
lithium battery) with a new one.
When the lithium battery becomes
weak, the operating distance of the
remote control may shorten, or the
remote control may not function
properly. In this case, replace the
battery with a Sony CR2025
lithium battery. Use of another
battery may present a risk of fire or
explosion.
Replacing procedures:
CD-ROM (Handbook) page 9
zTip
The 1 (standby) button on the
remote control cannot be used when
the photo frame is powered only by
the built-in battery pack. Use the 1
(standby) button on the photo frame.
P Notes
If you extend the stand in step 1
without sliding it to the limit in the
direction of arrow B, the stand
may be damaged.
Be sure that the stand is set in a
stable position when you place the
photo frame. It may fall unless the
stand is extended to the limit.
P WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or
dispose of in fire.
Continued