Filter
Top Products
46
GB
Connecting a digital camera or other external device
Photo frame
Remote control
Symptom Check item Cause/Solutions
The camera is
connected but
nothing is
displayed.
• Is the cable connected
properly?
c Connect the cable properly.
• Is the photo frame turned
on?
c Turn the photo frame on.
Nothing happens
even if the USB
cable is
disconnected and
then connected.
—
c An over current error may have occurred
with the photo frame. To recover from the
error, turn the power of the photo frame
off and then back on.
Images are not
displayed on the
TV screen or LCD
screen.
• The input of the TV is set to
the external input.
c Even if the input of the TV is not set to the
photo frame, images may sometimes not
be displayed on the TV screen or LCD
screen if an HDMI cable is connected.
c Change the input of the TV to the photo
frame, or disconnect the HDMI cable and
switch the display to the LCD screen.
Symptom Check item Cause/Solutions
Nothing happens
even if you operate
the photo frame.
—
c Push reset switch on rear side of the photo
frame by thin object such as a pin, etc.
Symptom Check item Cause/Solutions
Nothing happens
even if you operate
the remote control.
• Is the battery inserted in the
remote control properly?
c Replace a new battery. (.page 16)
c Insert a battery. (.page 16)
c Insert a battery in proper orientation.
(.page 16)
—
c Point the top end of the remote control
towards the remote sensor on the photo
frame. (.page 16)
c Remove any obstruction between the
remote control and remote sensor.