Filter
Top Products
80
The image seen through the finder does not indicate the actual recordable
range.
• The parallax phenomenon is occurring when the subject is close. To confirm the recordable
range, use the screen.
Cannot shoot images in succession.
• The internal memory or the “Memory Stick” is full. Delete unnecessary images (t step 6 in
“Read This First”).
• The battery level is low. Install charged batteries.
Refer to “Computers” (page 81) in conjunction with the following items.
Your camera cannot play back images.
• Set the mode dial to (page 25).
• The folder/file name has been changed on your computer.
• When an image file has been processed by a computer or when the image file was recorded
using a model other than that of your camera, playback on your camera is not guaranteed.
• The camera is in USB mode. Delete the USB communication (page 61).
The image appears rough right after playback starts.
• The image may appear rough right after playback starts due to image processing. This is not a
malfunction.
The image does not appear on the TV screen.
• Check [Video Out] to see if the video output signal of your camera is set to the color system of
your TV (page 53).
• Check whether the connection is correct (page 74).
• The USB cable is connected. Disconnect it according to the correct procedure (page 61).
The image does not appear on the screen.
• If the AV cable is connected, disconnect it (page 74).
Your camera cannot delete an image.
• Cancel the protection (page 39).
• Set the write-protect switch on the “Memory Stick” to the recording position (page 89).
Viewing images
Deleting/Editing images