Filter
Top Products
40 Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
If using a
1
/2” lens other than the VCL-716BX/
719BX on DSR-370/370P
If the connector on the lens attachment section is a 14-
pin connector (VCL-714BXA and other lenses), then
the lens may be operated in the same way as the VCL-
716BX/719BX.
If the lens has a 7-pin connector, then the following
limitations apply.
• The lens iris f. value is not displayed in the
viewfinder.
• Iris operation may be slow in auto iris mode, and
hunting may occur. If this happens, you should adjust
the iris sensitivity (see page 135).
If using a lens with a 6-pin connector
This camcorder head has a 12-pin LENS connector. If
the lens cable has a 6-pin connector, fit an adaptor
cable: LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
When using a lens with a 6-pin connector, the
following limitations apply.
• The lens iris f. value is not displayed in the
viewfinder.
• Iris operation may be slow in auto iris mode, and
hunting may occur. If this happens, you should adjust
the iris sensitivity (see page 135).
If using a
2
/3” lens (for only DSR-370/370P)
Fit the lens using the optional LO-32BMT
2
/3” lens
adaptor.
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter.
Use a commercially available M82 × 0.75 size screw
to attach the filter.
Remove lens hood
Lens hood fixing
screw
Filter (optional)
Fitting the Lens