Filter
Top Products
36 Location and Functions of Parts and Controls
Rear
E Remote sensors
F IMAGE FLIP switch
Flips the image upside down. Normally
set this to OFF when you use the camera.
When the camera is attached to the
ceiling, set this to ON. Before you set the
IMAGE FLIP switch, turn off the unit
(or set to standby mode) and then, turn
the power on by connecting the power
adaptor, by VISCA control or the remote
commander. When you switch this, the
preset setting is returned to the initial
setting. It takes about 7 to 16 seconds for
the image displayed to respond to the
setting change.
G IR SELECT switch
Select the camera number when you
operate multiple cameras with the same
remote commander.
H VISCA RS-422 connector
To communicate via RS-422, use this
connector.
Use the supplied VISCA RS-422
connector plug.
I VIDEO(output) connector
J S VIDEO(output) connector
K VISCA IN connector
Connect to a computer via an RS-232C
interface. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
L VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
M DC 12 V connector
Use only the polarity plug (standard
JEITA/type 4).
Note
Polarity of the plug