Filter
Top Products
8
Getting Started
Step 1: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) after attaching
it to your camcorder.
Notes
You cannot attach any “InfoLITHIUM” battery
pack other than the H series to your camcorder.
1 Connect the AC Adaptor to the DC
IN jack on the Handycam Station.
Be sure that the mark on the DC plug
is facing up.
2 Connect the power cord (mains
lead) to the AC Adaptor and the wall
outlet (wall socket).
3 Slide the POWER switch in the
direction of the arrow to OFF (CHG)
(the default setting).
4 Attach the battery pack by sliding it
in the direction of the arrow until it
clicks.
5 Set the camcorder onto the
Handycam Station securely.
e /CHG (charge) lamp lights up and
charging starts. e /CHG (charge)
lamp turns o when the battery pack is
fully charged. Remove the camcorder
from the Handycam Station.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
Battery pack
DC IN jack
DC plug
AC Adaptor
Power cord
(Mains lead)
To the wall outlet
(wall socket)
/CHG lamp
POWER switch