Filter
Top Products
73
US
Others/Index
The battery pack is nearly used up.
The battery pack temperature is high. Change
the battery pack or place it in a cool place.
No memory card is inserted (p. 25).
When the indicator flashes, there are not
enough free spaces for recording images.
D
elet
e unnecessary images (p. 51), or format
the memory card after storing the images on
o
th
er media (p. 69).
The image data base file may be damaged.
Check the data base file by selecting
[Setup] [
Media Settings] [Repair
Img. DB F.] the recording medium (HDR-
CX260V/CX580V/PJ260/PJ260V/PJ580/
PJ580V/PJ600/PJ600V/XR260V).
The memory card is damaged.
Format the memory card with your camcorder
(p.
69).
Incompatible memory card is inserted (p. 26).
The memory card is write-protected.
Access to the memory card was restricted on
another device.
There is something wrong with the flash.
The amount of lights is not sufficient, so
camera-shake easily occurs. Use the flash.
The camcorder is unsteady, so camera-shake
easily occurs. Hold the camcorder steady with
both hands and record the image. However,
note that the camera-shake warning indicator
does not disappear.
The drop sensor function (p. 69) is activated,
and has detected that the camcorder has been
dropped. Therefore, the camcorder is taking
steps to protect the internal hard disk.
Recording/playback may be disabled as a
result.
The drop sensor function does not guarantee
the protection of the internal hard disk under
all possible situations. Use the camcorder
under stable conditions.
The recording medium is full.
Photos cannot be recorded during processing.
Wait for a while, then record.
When [
REC Mode] is set to [Highest
Quality
] or [60p Quality ], you cannot
capture photos while recording movies.
Furthermore, if [
Frame Rate] is set to
[24p] (HDR-CX580V/PJ580/PJ580V/PJ600/
PJ600V), you cannot record photos while
the camcorder is in movie recording standby
mode.