Filter
Top Products
Administrating the Camera
Setting the Object Detection Function — Object detection Menu
71
Unattended object setting Tab
Use this tab to set the alarm time for unattended object
detection.
Time setting
Unattended object detection requires the following three
kinds of time settings.
Detection time
Set the period of time from when an object enters a
detection window (active window) and stops until when
it is regarded as an unattended object. An alarm will be
output if the specified period has elapsed.
You can set the time between 40 seconds and 12 hours.
Note
If Stay time for the tour function specified in the Preset
position menu (page 49) is shorter than Detection time,
the camera will move to the next preset position before
the object is regarded as an unattended object.
Alarm interval
You can repeat the alarm output in an interval of the
preset time after an object has been regarded as an
unattended object.
If you set Alarm interval to 5 minutes, for example, so
that an alarm will be output every 5 minutes repeatedly
after an unattended object is detected.
You can set the time between 1 and 6 hours.
Release time
Set the period of time required when the object once
regarded as an unattended object is regarded as a
background.
An alarm will no longer be output if the specified period
has elapsed as the object once regarded as an unattended
object is regarded as a background.
You can set the time between 1 and 12 hours.
Note
Set Release time to a larger value than Detection time.
Configuration Tab
Setting list
Lists the settings for each position: Moving object
detection, Unattended object detection, None.
Note
If you select Moving object or Unattended object in
the Common tab when no window is set to Active, None
is displayed in the list.