Filter
Top Products
Setting for Wireless Network
(SNC-M1W/M3W only)
To use the camera in a wireless network via an access
point, set as follows.
Use the network cable for connection when you assign a
new IP address to the SNC-M1W/M3W wireless network
camera.
1
Display the welcome page of the
camera following the procedure of
“Monitor the Image of the Camera” on
page 7.
2
Click “Setting.”
3
Type the user name and password for
the administrator, then click “OK.”
The default settings of both items are “admin.”
The “Administrator” menu is displayed.
4
Click “Network.”
The “Network setting” menu appears.
5
Click the “Wireless network” tab.
6
Set the items for the wireless network.
a Select “Infrastructure” on “Type.”
b Enter the “SSID” to match the setting on the
access point.
c Enter the “WEP key data” to match the
settings on the access point.
d Click “OK.”
7
Turn off the power of the camera.
8
Remove the network cable from the
camera.
9
Turn on the power of the camera
without connecting the network cable.
The Wireless setting is now enabled.
Click.
Click.
Type the user name.
Type the password.
Click.
1 Infrastructure
3 WEP key
data
2 SSID
4 OK
Sony Corporation