Filter
Top Products
Administrating the Camera
Sending Images to FTP Server — FTP client setting Page
30
Network address/Subnet 1 to Network
address/Subnet 10
Type the IP addresses and subnet mask values you want
to allow or deny access to the camera.
You can specify up to 10 IP addresses and subnet mask
values. For a subnet mask, type 8 to 32.
To temporarily cancel the Default Policy for a specified
IP address/subnet mask, select Allow or Deny from the
drop-down list on the right.
Tip
The subnet mask value represents the bit number from
the left of the network address.
For example, the subnet mask value for 255.255.255.0 is
24.
If you set “192.168.0.0/24, Allow,” you can allow access
from the computers having an IP address between
192.168.0.0 and 192.168.0.255.
Note
You can access the camera even from a computer having
the IP address whose access right is set to Deny, if you
enter the user name and password set for Level 4 access
right on the authentication dialog displayed.
OK/Cancel
See “Buttons common to every setting page” on page
17.
Sending Images to FTP
Server
— FTP client setting Page
When you click FTP client on the Administrator menu,
the FTP client setting page appears.
Use this page to set up for capturing and sending still
images to an FTP server. You can capture a still image
at the moment when a trigger occurs by an external
sensor input, the built-in activity detection function or a
manual trigger button, or capture sequenced still images
before and after the trigger. The captured still image(s)
is sent to the FTP server (FTP client function). You can
also send still images periodically.
Activating/Deactivating the FTP
Client Function
— FTP client usage setting Page
To activate the FTP client function, select Use FTP
client function and click OK. The FTP client setting
page appears.
When you do not use the FTP client function, select Do
not use FTP client function and click OK.
Note
The frame rate and operability on the main viewer page
may decrease while a file is being transmitted by the
FTP client function.
Setting the FTP Client Function
— FTP client setting Page