Filter
Top Products
93
Editing
Monitoring the new recorded sound
The POWER switch should be set to .
Operate by touching the panel.
(1) Play back the tape on which you added audio.
(2) Press FN to display PAGE1.
(3) Press MENU to display the menu.
(4) Select AUDIO MIX in
, then press EXEC (p. 170).
(5) Press r/R to adjust the balance between the original sound (ST1) and the new
sound (ST2), then press EXEC.
About five minutes after you disconnect the power source or remove the
battery pack, the setting of AUDIO MIX returns to the original sound (ST1)
only. The default setting is original sound only.
Audio dubbing
VCR SET
H i F i SOUND
AUD
I
O M
I
X
A
/
VcDV OUT
ST1 ST2
EXIT
RET.
EXEC
Rr